。

# Antenna Rotator Installation Guide

Antenna Rotator Installation Guide

Installing an antenna rotator can significantly improve your signal reception by allowing you to adjust the direction of your antenna for optimal performance. This guide will walk you through the steps to properly install an antenna rotator.

Tools and Materials Needed

Before you begin, gather the following tools and materials:

• Antenna rotator unit
• Mounting hardware (usually included with the rotator)
• Wrench set
• Screwdrivers
• Drill with appropriate bits
• Measuring tape
• Level
• Weatherproof sealant
• Coaxial cable
• Control cable (for rotator)

Step 1: Choose the Right Location

Select a sturdy mounting location for your rotator. This is typically on the mast below your antenna. Ensure the location is:

• Strong enough to support the weight of both the antenna and rotator
• Accessible for maintenance
• Clear of obstructions that might interfere with rotation

Step 2: Mount the Rotator

Follow these steps to mount the rotator:

1. Position the rotator on the mast according to manufacturer instructions
2. Use the provided U-bolts to secure the rotator to the mast
3. Ensure the rotator is level using your level tool
4. Tighten all bolts securely

Step 3: Connect the Antenna

Attach your antenna to the rotator’s output shaft:

1. Remove any existing mounting hardware from the antenna
2. Align the antenna with the rotator’s output shaft
3. Secure the antenna using the provided hardware
4. Ensure all connections are tight and weatherproof

Step 4: Run the Cables

Carefully route both the coaxial cable and rotator control cable:

• Use weatherproof sealant at all entry points
• Secure cables every few feet to prevent wind damage
• Leave some slack near the rotator for movement
• Avoid sharp bends in the cables

Step 5: Connect to the Control Unit

Inside your home or operating location:

1. Connect the control cable to the rotator control unit
2. Connect the coaxial cable to your receiver
3. Plug in the control unit power supply

Step 6: Test the System

Before finalizing the installation:

1. Power on the control unit
2. Test rotation in both directions
3. Check for smooth operation without binding
4. Verify signal reception at various positions

Maintenance Tips

To keep your antenna rotator functioning properly:

• Lubricate moving parts annually with